The EN749 standard specifies safety requirements and test methods for Handball and Futsal goals. It mandates that goals must withstand specific vertical and horizontal forces without tipping over. Using this anchoring kit ensures the goal is legally compliant, preventing serious accidents caused by structural collapse.

These are high-resistance threaded rods. With a length of 200mm and a thickness of 16mm, they ensure deep and robust anchoring into the ground. They are installed at the goal base's fixing points (typically 2 per post or at the rear supports).

Unlike traditional mechanical wall plugs, chemical resin creates a structural bond between the anchor bolt and the substrate (concrete).

• The resin (composed of resin + hardener) is automatically mixed in the nozzle of the gun.

• As it cures, it bonds into the pores of the material, making it virtually impossible to pull out.

This system is ideal for rigid surfaces (concrete), common in outdoor multi-sport courts or indoor arena foundations.

Note: If the floor is floating or has an air chamber (like some wooden sports floors), the drilling must reach the concrete base beneath the wood/synthetic layer to guarantee EN749 compliance.

The time depends on the ambient temperature, but generally:

• Partial drying: 30 to 60 minutes (the anchor can no longer be moved).

• Full drying: 24 hours (the point at which the goal can withstand game impacts or be used in competition